Troubleshooting Pro
Rear-view tracking
The rider's right side appears on the right of the screen. Is that right?
Correct. Filmed from behind, the rider's right stays on the right of the screen; the front view, filmed facing the rider, puts it on the left. Mixing up the two is the usual source of left-right errors when reading rear-view results.
Why aren't the PSIS points tracking?
The landmarks have to be visible: form-fitting kit or a bare lower back, and even light across it. Loose clothing at the lower back is the most common cause. Record again rather than interpret a poorly tracked pelvis.
Why isn't PSIS Trace offered?
PSIS landmarks exist only on rear-view recordings.
Why does the PSIS Trace look distorted?
Usually the capture: the camera not level, the camera moving, or poor light on the lower back.
Why is Knee Angle on the rear view under a degree?
Rear-view Knee Angle is the knee's tilt in the frontal plane, not the side-view knee angle. Small values are expected.
Spinal Bend reads in the high 170s. Is that normal?
180° is a straight line, and values in the high 170s are typical.
How do I see Left Bend when Upper Body Balance shows Right Bend?
Scrub to the frame where the left leg is at bottom dead center, or tap the left half of the graph on the full-size panel.
Why does Right Bend differ slightly from Spinal Bend in the Video view?
Spinal Bend is measured on every frame; Right Bend and Left Bend are that same measurement at each leg's bottom-dead-center frame. Different frames give slightly different values.
Why is there no Classic Dashboard for the rear view?
Classic Dashboard is for side recordings only. Rear-view analysis is in the EZ Dashboard's three modes and in the Video view.